AGA and Range Cooker Removal

North Tyneside · North East

AGA and Range Cooker Removal in Wallsend

If your Wallsend kitchen is held hostage by a 400 kg cooker, we can take it apart and remove it in a single day.

Old AGA in Wallsend? Request a quote to dismantle and remove it.

Free AGA and Range Cooker Removal quote in Wallsend

No obligation. We only use your details to reply about this job.

Where we work around Wallsend

Wallsend is in the North Tyneside council area in the North East. Jobs here are mostly in the NE28, NE29, NE27 and NE6 postcode areas. The same team covers Tynemouth, Longbenton, Hebburn, Killingworth and Shiremoor too.

AGA and Range Cooker Removal in Wallsend: local know-how

If your Wallsend AGA sits in a kitchen-diner, we seal off the area as far as possible to limit insulation dust. Many Wallsend families replace an AGA with a modern range during an extension or kitchen refit, and we time the removal to suit the builder.

The North East has a high share of terraced and colliery-era housing, with modern estates growing around its larger towns. Flue pipes in older Wallsend homes may be asbestos cement, so we recommend testing before any work starts.

Typical costs in Wallsend

  • Fuel disconnection by qualified engineer: £75–£150. Gas Safe, OFTEC or electrical isolation, depending on the cooker's fuel type.
  • Rayburn or Stanley with boiler: £350–£600. Heating system must be drained and capped by a plumber before work starts.
  • Three or four-oven AGA: £450–£750. Longer dismantle and more castings to carry; route and access affect price.

Prices are a guide. Your quote for Wallsend is a fixed price based on the details you give us. Full price guide.

AGA and Range Cooker Removal questions from Wallsend

How much does AGA removal cost in Wallsend?

AGA removal in Wallsend typically costs £350–£550 for a two-oven model and £450–£750 for three or four ovens, including dismantling, clean-up and recycling. Fuel disconnection is extra if needed. Send photos for a fixed price.

Can you arrange an engineer to disconnect my AGA in Wallsend?

Yes. We can arrange a Gas Safe engineer, OFTEC technician or electrician in Wallsend, depending on your cooker's fuel, so it is safely isolated before our dismantling team arrives.

How long does AGA removal take in Wallsend?

Most two-oven AGA removals in Wallsend take three to five hours. Larger models, Rayburns with boilers, or long carries to the van can take most of a day. Switch the cooker off at least 24 hours beforehand.

Do you remove Rayburns in Wallsend?

Yes. We remove Rayburns, Stanleys and Esse cookers in Wallsend and nearby Jarrow. If the cooker runs your heating, a plumber must drain and cap the system first, and we can coordinate timings.

How heavy is an AGA cooker?

A traditional two-oven cast-iron AGA weighs around 400 kg, and larger four-oven models weigh considerably more. That is why AGAs are never moved in one piece. They are dismantled on site into hotplates, oven castings and panels, the heaviest of which weigh roughly 50–90 kg and can be carried by two people.

Who disconnects an oil-fired AGA?

Oil-fired AGAs and Rayburns are normally disconnected by an OFTEC-registered technician, who isolates the oil supply and caps the line. Gas and LPG models need a Gas Safe registered engineer, and electric models a competent electrician. We can arrange the right engineer for your cooker so it is safe before dismantling begins.

Get a free aga and range cooker removal quote in Wallsend

Tell us what you need and we'll come back with a clear price.

Request a quote