AGA and Range Cooker Removal

Perth and Kinross · Scotland

AGA and Range Cooker Removal in Perth

We dismantle and remove cast-iron AGAs, Rayburns and range cookers from homes across Perth, recycling or reconditioning the castings.

Get a fixed price for AGA removal in Perth today.

Free AGA and Range Cooker Removal quote in Perth

No obligation. We only use your details to reply about this job.

Covering Perth and nearby

Perth falls within Perth and Kinross, Scotland. Jobs here are mostly in the PH1 and PH2 postcode areas. We also take jobs in Scone, Bridge of Earn, Almondbank and Luncarty.

What to expect in Perth

In Scotland, building warrants are issued by the local council, and much of the older stock is stone-built with harling or render. Post-2000 kitchens in Perth often have engineered flooring, which we protect with boards and skates throughout. Stone-built houses and tenements in Perth can have narrow stairs and thick walls, so castings are carried out piece by piece.

In Perth detached homes, side access often gives a shorter route for castings than carrying them through the house. If your Perth AGA sits in a kitchen-diner, we seal off the area as far as possible to limit insulation dust.

AGA and Range Cooker Removal prices in Perth

  • Two-oven AGA dismantle and removal: £350–£550. Full on-site strip-down, insulation removal, clean-up and cast-iron recycling.
  • Modern range cooker, 90–110cm: £110–£180. Three-person team with skates and trolleys; fuel supply must be capped first.
  • Asbestos sampling before removal: from £150. Recommended for older cookers or flues of unknown history before any dismantling.

Prices are a guide. Your quote for Perth is a fixed price based on the details you give us. Full price guide.

AGA and Range Cooker Removal questions from Perth

Do you remove Rayburns in Perth?

Yes. We remove Rayburns, Stanleys and Esse cookers in Perth and nearby Glenrothes. If the cooker runs your heating, a plumber must drain and cap the system first, and we can coordinate timings.

Can you remove a range cooker from my Perth kitchen?

Yes. We remove modern range cookers in Perth using a three-person team, skates and trolleys. The gas must be capped by a Gas Safe engineer first, which we can arrange.

Do builders in Perth use your AGA removal service?

Yes. Kitchen designers and builders across Perth and Kinross use us to remove AGAs before a refit, saving their crews a heavy, dusty day and keeping the Perth project on schedule.

How long does AGA removal take in Perth?

Most two-oven AGA removals in Perth take three to five hours. Larger models, Rayburns with boilers, or long carries to the van can take most of a day. Switch the cooker off at least 24 hours beforehand.

What should I do to prepare for AGA removal?

Switch the cooker off at least a day before, arrange or confirm the fuel disconnection, and clear the kitchen of anything fragile. Empty the warming oven and remove any rails or utensils hung on the cooker. Make sure there is parking close to the door for a van, and tell us about steps or narrow corridors on the route.

Who disconnects an oil-fired AGA?

Oil-fired AGAs and Rayburns are normally disconnected by an OFTEC-registered technician, who isolates the oil supply and caps the line. Gas and LPG models need a Gas Safe registered engineer, and electric models a competent electrician. We can arrange the right engineer for your cooker so it is safe before dismantling begins.

Get a free aga and range cooker removal quote in Perth

Tell us what you need and we'll come back with a clear price.

Request a quote